TriMetric Meter Amp-Hour Meter
The Tri-Metric 2020 meter displays amp-hours, net current flow and battery % full on an LED display. The fuel gauge for your batteries !!
The TriMetric battery monitor is designed to assist in battery care, conservation and system maintenance of battery powered systems that use storage batteries with system voltage from 12-48 volts. (48 volt system require adaptor)
It provides the user with information on battery "volts", "amps" and "amp-hours" and "battery percent full" information, based on measuring the amp-hours removed from the battery system. Reliability, accuracy and simplicity are key product objectives. The TriMetric requires an external shunt located near the batteries to measure "amps" and "amp-hours". The meter readout may be located hundreds of feet away from batteries and is usually connected to the shunt with a 4 wire cable.
An LED lights when the battery is charging and flashes when the battery has been fully charged. Another LED flashes when batteries should be recharged or equalized, and during low battery voltage. It also records minimum and maximum voltage, days since batteries were last charged, days since equalized, and total lifetime amp-hours withdrawn from the batteries. The Trimetric can be located hundreds of feet away from the batteries using 4 conductor meter wire.
For 48 V systems or additional lightning protection on 12/24 V systems, use a 48 V adapter with the meter. A shunt is required for operation. Use the 500 Amp shunt if you have a 12 V inverter larger than 1600 watts. Use the 1000 Amp 100mV shunt for systems with stacked SW inverters or where continuous current is over 300 amps. Order shunt separately.
Handles a maximum battery bank size of 2500 amp hours. The positive lead to the Trimetric should be fused with a 1 amp fuse. Flush mount or use wiremold box to mount.
Two year warranty.
TriMetric Battery Monitor TM2020
(picture shown with wiring box sold seperate)
